style of the fingers

space at the start and end in multiple of normal spaces

height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!

space below holes of FingerHoleEdge (multiples of thickness)

extra material to grind away burn marks (multiples of thickness)

width of the fingers (multiples of thickness)

extra space to allow finger move in and out (multiples of thickness)

space between fingers (multiples of thickness)

width of finger holes (multiples of thickness)

head diameter of mounting screw (in mm)

shaft diameter of mounting screw (in mm)

minimum space left and right without holes (fraction of the edge length)

number of mounting holes (integer)

side of box (not all valid configurations make sense...)

edge style

height above the wall in mm

height of hole(s) in percentage of maximum hole height (handle height - 2 * material thickness)

width of hole(s) in percentage of maximum hole width (width of edge - (n+1) * material thickness)

added to side panels if checked, to front and back otherwise (only used with top_edge parameter)

radius of corners in mm

extend the handle along the length of the edge (multiples of thickness)

inner width in mm (unless outside selected)

inner depth in mm (unless outside selected)

sections bottom to top in mm 🛈

treat sizes as outside measurements 🛈

edge type for top edge

Add full height of topmost rack to the back panel

height of walls

height of the back as fraction of the front height

edge type holding the shelves together

Make bottom Flat, so that the rack can also stand

Thickness of the material [mm]

Burn correction [mm] (bigger values for tighter fit)

Format of the resulting file

Label the parts (where available)

Print reference rectangle with given length [mm] (0 to disable)

Width of tabs holding parts in place [mm]

Add a QR Code with link or command line to the generated output

Style for inner corners

Spacing around parts (multiples of thickness [: extra space in mm])

Print surrounding boxes for some structures