style of the fingers

space at the start and end in multiple of normal spaces

height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!

space below holes of FingerHoleEdge (multiples of thickness)

extra material to grind away burn marks (multiples of thickness)

width of the fingers (multiples of thickness)

extra space to allow finger move in and out (multiples of thickness)

space between fingers (multiples of thickness)

width of finger holes (multiples of thickness)

type of handle

type of lid to create

height of the handle in multiples of thickness (if applicable)

height of the brim in multiples of thickness (if any)

play when sliding the lid on in multiples of thickness (if applicable)

sections left to right in mm 🛈

inner depth in mm (unless outside selected)

inner height in mm (unless outside selected)

treat sizes as outside measurements 🛈

angle of the ramps

height of the ramps relative to to total height

have ramps on both sides. Enables sliding dividers

have a vertical wall at the ramp

Thickness of the material [mm]

Burn correction [mm] (bigger values for tighter fit)

Format of the resulting file

Label the parts (where available)

Print reference rectangle with given length [mm] (0 to disable)

Width of tabs holding parts in place [mm]

Add a QR Code with link or command line to the generated output

Style for inner corners

Spacing around parts (multiples of thickness [: extra space in mm])

Print surrounding boxes for some structures