style of the fingers

space at the start and end in multiple of normal spaces

height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!

space below holes of FingerHoleEdge (multiples of thickness)

extra material to grind away burn marks (multiples of thickness)

width of the fingers (multiples of thickness)

extra space to allow finger move in and out (multiples of thickness)

space between fingers (multiples of thickness)

width of finger holes (multiples of thickness)

how much should fingers widen (-80 to 80)

how far the dove tails stick out of/into the edge (multiples of thickness)

radius used on all four corners (multiples of thickness)

from one middle of a dove tail to another (multiples of thickness)

inner width in mm

inner depth in mm

the number of paper layers; don't forget the back (blank) layer!

the width of the paper layer frames

the height of the paper layer frames

cumulative height of your paper layers, play between frames, the LED strip, battery/wiring, anything else you want to fit in the case

whether or not to join sides to front plate (disable if doing manual joins on fancy wood)

edge type for back edge (and back wall)

Thickness of the material [mm]

Burn correction [mm] (bigger values for tighter fit)

Format of the resulting file

Label the parts (where available)

Print reference rectangle with given length [mm] (0 to disable)

Width of tabs holding parts in place [mm]

Add a QR Code with link or command line to the generated output

Style for inner corners

Spacing around parts (multiples of thickness [: extra space in mm])

Print surrounding boxes for some structures