SevenSegmentPattern

Hole patterns › SevenSegmentPattern

Holepatterns and walls for a seven segment digit

This pattern is indented to be used with a LED stripe that is wound through all segments in an S pattern while the stripe being upright on its side. It can also be used with small pieces of LED stripes connected with short wires for large enough sizes.

Settings for Finger Joints

style

style of the fingers

surroundingspaces

space at the start and end in multiple of normal spaces

bottom_lip

height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!

edge_width

space below holes of FingerHoleEdge (multiples of thickness)

extra_length

extra material to grind away burn marks (multiples of thickness)

finger

width of the fingers (multiples of thickness)

play

extra space to allow finger move in and out (multiples of thickness)

space

space between fingers (multiples of thickness)

width

width of finger holes (multiples of thickness)

SevenSegmentPattern Settings

digit

height of the digit (without walls) in mm

height separation walls in mm

Default Settings

thickness

Thickness of the material [mm]

burn

Burn correction [mm] (bigger values for tighter fit)

format

Format of the resulting file

labels

Label the parts (where available)

reference

Print reference rectangle with given length [mm] (0 to disable)

tabs

Width of tabs holding parts in place [mm]

qr_code

Add a QR Code with link or command line to the generated output

inner_corners

Style for inner corners

spacing

Spacing around parts (multiples of thickness [: extra space in mm])

debug

Print surrounding boxes for some structures