style of the fingers

space at the start and end in multiple of normal spaces

height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!

space below holes of FingerHoleEdge (multiples of thickness)

extra material to grind away burn marks (multiples of thickness)

width of the fingers (multiples of thickness)

extra space to allow finger move in and out (multiples of thickness)

space between fingers (multiples of thickness)

width of finger holes (multiples of thickness)

height above the wall

radius of hole

radius of top corner

extend the triangle along the length of the edge (multiples of thickness)

inside angle of the feet

height of strips to be glued to the inside of bottom edges (multiples of thickness)

height of the feet (multiples of thickness)

distance from finger holes to bottom edge (multiples of thickness)

width of the feet (multiples of thickness)

head diameter of mounting screw (in mm)

shaft diameter of mounting screw (in mm)

minimum space left and right without holes (fraction of the edge length)

number of mounting holes (integer)

side of box (not all valid configurations make sense...)

edge style

type of handle

type of lid to create

height of the handle in multiples of thickness (if applicable)

height of the brim in multiples of thickness (if any)

play when sliding the lid on in multiples of thickness (if applicable)

edge type for top edge

sections left to right in mm 🛈

sections back to front in mm 🛈

sections bottom to top in mm 🛈

edge type for bottom edge

Number of holes for each size

Smallest hole

increment between holes

Thickness of the material [mm]

Burn correction [mm] (bigger values for tighter fit)

Format of the resulting file

Label the parts (where available)

Print reference rectangle with given length [mm] (0 to disable)

Width of tabs holding parts in place [mm]

Add a QR Code with link or command line to the generated output

Style for inner corners

Spacing around parts (multiples of thickness [: extra space in mm])

Print surrounding boxes for some structures