DividerTray - Boxes

← 🏠

Divider tray - rows and dividers

Adding '0:' at the start of the sy parameter adds a slot at the very back. Adding ':0' at the end of sy adds a slot meeting the bottom at the very front. This is especially useful if slot angle is set above zero.

There are 4 different sets of dividers rendered:

With asymmetric tabs so the tabs fit on top of each other
With tabs of half wall thickness that can go side by side
With tabs of a full wall thickness
One single divider spanning across all columns

You will likely need to cut each of the dividers you want multiple times.

Picture of box.

Import