inside angle of the feet

height of strips to be glued to the inside of bottom edges (multiples of thickness)

height of the feet (multiples of thickness)

distance from finger holes to bottom edge (multiples of thickness)

width of the feet (multiples of thickness)

the angle of arc cuts

the gap between grooves (fraction of the edge length)

alternate the direction of grooves

invert the groove directions

minimum space left and right without grooves (fraction of the edge length)

the style of grooves

the angle of triangular cuts

the width of each groove (fraction of the edge length)

style of the fingers

space at the start and end in multiple of normal spaces

height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!

space below holes of FingerHoleEdge (multiples of thickness)

extra material to grind away burn marks (multiples of thickness)

width of the fingers (multiples of thickness)

extra space to allow finger move in and out (multiples of thickness)

space between fingers (multiples of thickness)

width of finger holes (multiples of thickness)

sections left to right in mm 🛈

inner depth in mm (unless outside selected)

inner height in mm (unless outside selected)

treat sizes as outside measurements 🛈

backward angle of floor

make holders stackable

Thickness of the material [mm]

Burn correction [mm] (bigger values for tighter fit)

Format of the resulting file

Label the parts (where available)

Print reference rectangle with given length [mm] (0 to disable)

Width of tabs holding parts in place [mm]

Add a QR Code with link or command line to the generated output

Style for inner corners

Spacing around parts (multiples of thickness [: extra space in mm])

Print surrounding boxes for some structures