style of the fingers

space at the start and end in multiple of normal spaces

height of the bottom lips sticking out (multiples of thickness) FingerHoleEdge only!

space below holes of FingerHoleEdge (multiples of thickness)

extra material to grind away burn marks (multiples of thickness)

width of the fingers (multiples of thickness)

extra space to allow finger move in and out (multiples of thickness)

space between fingers (multiples of thickness)

width of finger holes (multiples of thickness)

inner width in mm (unless outside selected)

inner depth in mm (unless outside selected)

inner height in mm (unless outside selected)

inner height of inner walls in mm (unless outside selected)(leave to zero for same as outer walls)

treat sizes as outside measurements 🛈

play between fitting parts as multiple of the wall thickness

height of the inner drawer [mm]

reduce inner front wall to let drawer slide under it

number of magnets on the front walls (0 = none)

diameter of each magnet hole [mm]

centre-to-centre spacing between magnets (0 = auto, evenly distributed) [mm]

vertical offset of magnet holes from the auto position (0 = auto) [mm]

diameter of the side magnet hole on the right walls (0 = none) [mm]

Thickness of the material [mm]

Burn correction [mm] (bigger values for tighter fit)

Format of the resulting file

Label the parts (where available)

Reference rectangle length [mm]

Print the reference rectangle

Width of tabs holding parts in place [mm]

Add a QR Code with link or command line to the generated output

Style for inner corners

Spacing around parts (multiples of thickness [: extra space in mm])

Print surrounding boxes for some structures